|
The Praga E.114 was a single-engine sport airplane, designed and manufactured by the Czechoslovakian company ČKD-Praga. Due to its light weight it was also called Air Baby. ==Design and development== The Praga E.114, first flown in 1934 and designed by Jaroslav Šlechta, was a high wing, cantilever monoplane seating two in a side-by-side cabin. It was an all wood aircraft with a two spar single piece wing; the spars and ribs were built from pine and plywood and the wing plywood covered. The wing section was reflexed at the trailing edge. The wing had a constant chord centre section with taper on the trailing edge outboard and rounded tips. The ailerons were plywood covered and unbalanced.〔〔 Its fuselage was a pine framed, plywood covered hexagonal box, with the straight edged fin an integral part. The rudder was rounded and horn balanced. Though the rudder was wood framed and covered, the tailplane, mounted just above the fuselage and externally braced from below, had a tube steel structure and was fabric covered. The elevators were balanced by an elastic rope to the control column.〔〔 Early in the design process the E.114 had been envisaged as an open cockpit aircraft but by the time of construction there was an enclosed cabin. The first prototype had rather crude glazing constructed from plane panes. The absence of doors made entry somewhat challenging, with the side panels hinged down and the upper pane, together with part of the wing leading edge hinged upwards. The second prototype added a lower fuselage foothold to ease the process, as well as fitting less angular glazing. The undercarriage, which was also used as a first step into the cabin, was of the divided type with faired legs hinged on the lower fuselage, assisted by struts from the centre line to the wheels. The wheels contained rubber shock absorbers and were optionally spatted〔〔 Early aircraft were powered by a 29 kW (36 hp) Aeronca air-cooled flat four engine mounted in the extreme nose with its cylinders exposed. Early production aircraft replaced the US-built Aeronca with a Czechoslovakian version of it, also built by Praga, called the Praga B. Later the similar but more powerful Praga B2 was fitted and from 1936 this was replaced in turn by the Praga D. This was another flat four, producing 49/55 kW (65/74 hp), with each pair of exposed cylinders merged into a single housing for lower drag. Aircraft with this engine were referred to as E.114D.〔 As well as benefiting from more power, the E.114D had other enhancements. The ailerons were balanced, improving the stall characteristics; the vertical surfaces were increased in area and given a more angular profile with a non-balanced rudder.〔 The last E.114 variant involving an engine change was the E.114M, fitted with a 49 kW (65 hp) Walter Mikron III four-cylinder inverted inline engine. The full cowling changed the look of the nose considerably and increased the length by 510 mm (20 in). The E.114M was the heaviest of the series, with an empty weight of 415 kg (915 lb); the E.114D weighed 330 kg (728 lb). The wing carried noticeable dihedral and the E.114M was the only one of its type to have a tailwheel rather than a skid. It was the fastest of the type, with a maximum speed of 185 km/h (115 mph).〔 The E.115 appeared in 1937 with significant changes to the wing. The span was only slightly reduced (by 200 mm or 7.9 in) but continuous taper reduced the area by 20%. The ailerons were fabric covered. It could be powered by either the Praga B or D and was noticeably faster than earlier variants, even with the smaller engine. The E.115 also had a revised undercarriage, with single, streamlined steel struts hinged to the lower fuselage braced by rods to the centre section. The wheels were spatted and the legs sprung with bungee cord inside the fuselage.〔〔 The E.117 of 1937 had major alterations. The wing was the same span as that of the E.114 but was given a straight taper, resulting in a small (3.3%) decrease in area. For the first time flaps (of the split type) were fitted. The wing remained wooden but a steel framed, fabric covered fuselage was used and the fin and elevator were similarly constructed. The new fuselage construction allowed the E.117 to have cabin doors for the first time, as well as a more generous interior. It had cantilever undercarriage legs, with wheels in fairings and a tailwheel in place of the skid used by most of the E.114s and E.115, though one of the only two E.117s built flew for a time with a tricycle undercarriage, its mainlegs moved rearwards and with a faired nosewheel assembly.〔 The E.214, which appeared in about 1936 or 1937 was essentially an E.114 with a 56 kW (75 hp) Pobjoy R seven-cylinder radial engine. The structure was the same as that of the E.114 and the wings had the same dimensions. With a length of 7.15 m (23 ft 5½ in), the E.214 was a few millimetres longer than the E.114M, despite the latter's much longer engine and the extension provided space for a second pair of seats behind the first, making the E.214 a four-seater. The new seats were accessed via a side door, though the front pair retained the side window route of the earlier aircraft. A trim tab on the elevator replaced the elastic rope balance and the undercarriage was also new, each side having an oleo leg fixed to the lower fuselage longeron and braced at its lower end by a V-form strut, hinged on the fuselage centreline. At 420 kg (926 lb), its empty weight was close to that of the E.114M. Maximum speed was 170 km/h (106 mph).〔 抄文引用元・出典: フリー百科事典『 ウィキペディア（Wikipedia）』 ■ウィキペディアで「Praga E.114」の詳細全文を読む スポンサード リンク
|